HS 960 – SCHIPS

Automatic strip cutter

HS 960 automatic strip cutter

Fully automatic cutting of elastic and non-elastic tapes, straps, laces, velcro-tapes, etc. width up to 165 mm (knife cut). Programming of several cutting orders with varying number of pieces and lengths in mm-steps from 1 mm to 10 meters.

The feed speed (maximum 60 meters per minute) can be optimally adjusted to suit the different materials.

High standard of repeating accuracy due to the high-tech mechanical components and the sophisticated electronics.

New option: Tape joint detection

For recognition of the bonded joint of 2 tape ends, with a new sensor. Aluminium bonding tape is not necessary for detection, the sensor also identifies paper and plastic adhesive tape joints. The high scanning speed doesn’t affect productivity. Optimal installation of the sensor is possible due to its compact design.

After recognition of the joint, the software calculates whether or not a complete piece still can be produced. The tape is then transported to just after the adhesive joint and cut. The waste will be discarded.

Options


UST 100 Ultrasonic cutting unit (cutting width max. 95 mm)	HS 201 Throw-over stacker, compact	HS 260-165 Clamp stacker



HS 263-500 Rotating stacker, length 500 mm	HS 263-1000 Rotating stacker, length 1000 mm	HS 264 Flat stacker with tape feed by stepper motor, SMD 40 stepper motor drive, stepper motor



Width change spindle Fast width of elastic guide by handwheel and spindle	Small tape For small tapes, 10 mm spring-mounted alu-pressure roller with special mounting bracket, smoothing brush for optimum working with small tapes	Tape Nr. 2, Tape Nr. 3 Simultaneous operation: independently spring-mounted presser roller, slack adjustment controlled by photocell, tape end detection by photocell, automatic join detection



Garter conversion kit Conversion kit for silicon coated garters, drive and pre-feed roller rubber coated, pressure rollers rubber coated, 20 mm in width, position adjustable on shaft, blower fitted to the cutting device, extra low mounting of photocell for slack adjustment, slack feed device, 220V up to 160 mm width with light sensor and tray	Monitoring of aluminium foil tape joins Monitoring of aluminium foil tape joins and thick sections with light sensor in front of the pre-feed roller	Measuring tape on angle Additional angle in front with measuring tape



Angle cut Angle cut with continuous twisting mechanism by stepper motor	Mark reading device Mark reading device for label cutting	Ionising device Ionising device for strong electrostatic charged tapes (depending on type of tape stronger devices on request)



Tape take-up monitoring Take-up on the front and rear pressure rollers controlled by light sensor